Inductive speed sensor, to be used with DL-32, LMA-3, SSI-4, LM-2
can be used to pickup speed signals from driveshaft or any other rotating assembly.
Stainless steel, sealed construction, with status LED to easily.
Case : Stainless steel, thread M8.
Power supply: 10-24VDC
Statuscontrol: with LED
Output current 100mA max.
Frequency: max. 2,5kHz
Temp. range: -25 bis +70°C
Detection range: max 2,5mm
Class of protection: IP68
Customers who bought this product also bought the following products:
 |
DL-32 Datalogger
|
 |
Exhaust clamp for O2 sensorPatent-pending, Venturi-effect, tapped exhaust clamp for obtaining accurate lambda measurements in non-cat autos or other engines. Pushing the O2 sensor into the tail pipe, without this exhaust clamp, does not deliver correct results 75,00 EUR (19 % VAT incl. excl. Shipping costs) |
 |
Window Mount for LM-2High Quality window mount for LM-2 49,00 EUR (19 % VAT incl. excl. Shipping costs) |
 |
LM-2 / DL-32 SD card 2GBMemory card for LM-2 or DL-32. SD 2GB required for data recording without PC 9,90 EUR (19 % VAT incl. excl. Shipping costs) |
 |
Sensorcable for LM-2, MTX-L 18ftExtended sensor cable 18ft, to connect the O² Sensor to the LMA-2 69,90 EUR (19 % VAT incl. excl. Shipping costs) |
 |
LM-2 Analog/RPM In/Out cableAnalog Input and Output Accessory Cable for LM-2 (Needed for RPM Input).and also for output of AFR signal to feed ino ECUs 24,89 EUR (19 % VAT incl. excl. Shipping costs) |
This Product was added to our catalogue on Tuesday 28 December, 2010.