TC-4 Thermocouple interface

Intake Air temp. sensor

for precise, fast and durable measurement of intake air temperature we do recommend this high quality Typ K probe.

Perfect in combination with LMA-3, DL-32 and TC-4.

79,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

Exhaust gas temp. sensor

for precise, fast and durable measurement of exhaust gas temperature we do recommend this high quality Typ K probe.

Perfect in combination with LMA-3, DL-32 and TC-4.

79,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

Therocouple wire (typ K)

1.8m Thermocouple wire to be used with DL-32, LMA-3, TC-4

7,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

USB to serial adapter

Adapred is required to connect our equipment to PCs without serial port (com1).
Adapter connects into USB port of PC.
Tested and approved to work without troubles, beware of low cost adapters.

(shipped adapter might be different from picture)

21,00 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

Serial programming cable for MTS devices

Required to connect a MTS device (SSI-4, TC-4, DL-32, LMA-3, OT-1) to a PC serial port (com1).

Not for USB connectivity

8,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

LMA-3 (AuxBox) Accessory Replacement Kit

Accessory kit for LMA-3

contains mounting hardware (screws & washers)

connector

hose clamp

14,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

Cable Daisy Chain MTS long, 2.5ft

This custom cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12.

2.5 ft. long

13,90 EUR

( 19 % VAT incl. excl. Shipping costs )

3-4 Days

DL-32 Datalogger

The DL-32 is a complete vehicle-mounted data-logging system for advanced engine tuning. The system is anchored by Innovate\'s award-winning digital wideband air/fuel ratio technology, but also includes flexiblke sensors for RPM, MAP, temperature, duty cycle, and analog inputs.

LC-1 Standalone Wideband Controller (Lambda Cable)

The LC-1 is a complete wideband controller built in to a sealed cable, to "survive" in an engine compartment, underneath your car, or attached to a motorcycles\' frame.

Bosch LSU4.2 5-wire, wide-band O2 sensor

Bung & Plug Extended (1 inch) Stainless Steel

Bung & Plug Extended (1 inch) Stainless Steel
Bung is Stainless Steel, plug is mild steel.

MTX-L: MTX Series Digital Air/Fuel Ratio Gauge Kit (ALL-IN-ONE

The new Innovate Motorsports Digital MTX Series Air/Fuel Ratio Gauge utilizes the only 100% digital Wideband air/fuel ratio technology on the market! The award-winning patented DirectDigital™ technology we use is faster and more accurate than common “UEGO” gauges and is now more affordable! In addition, the gauge features a water resistant casing, interchangeable faceplates and bezels, and 2 fully programmable linear analog outputs for use with aftermarket engine managements systems and dataloggers!

Exhaust clamp for O2 sensor

Patent-pending, Venturi-effect, tapped exhaust clamp for obtaining accurate lambda measurements in non-cat autos or other engines.

Pushing the O2 sensor into the tail pipe, without this exhaust clamp,  does not deliver correct results