LC-1 Standalone Wideband Controller (Lambda Cable)

The LC-1 is a complete wideband controller built in to a sealed cable, to "survive" in an engine compartment, underneath your car, or attached to a motorcycles' frame.

LC-1 Specifications
The LC-1 is a complete wideband controller built in to a sealed cable. It features the same award-winning patented digital measurement principal found in Innovate's LM-1, and includes digital input, output, and 2 programmable analog
outputs. The LC-1 one is more accurate than conventional designs costing many times as much. It's self-calibrating circuitry can compensate for changes in temperature, altitude and sensor condition. The LC-1 is ideal for applications
such as Dynos, Data Acquisition, Standalone ECUs, and Gauges. The LC-1 can be "daisy chained" for cost-effective individual cylinder tuning, and is fully compatible with Innovate's Modular Tuning System.

For owners of a TRIJEKT EFI system www.trijekt.de we do offer a special programming service, free of charge. We do program the required LC-1 settings for you. Just pick the option when ordering.

POWER:  
Operating Voltage                   9V-25V
Input Current, Operating        0.8A Typical
Input Current, Max                   2.5A during sensor-heater warmup                     
SENSOR:                                  Bosch LSU4.2 
MEASUREMENTS:        
Lambda                                    0.6 to Free Air (serial port only) 0.6 to 1.5 @ analog output
AFR                                           8.8 to Free Air (serial port only) 7.35 to 22.39 @ analog output

(Gasoline - Other Fuels Programmable)
ACCURACY:                            For Lambda <1 (9-15 AFR)     +/-0 .1 AFR                   
RESPONSE TIME:                  Free air to Lambda 0.8 (11.7AFR)  <100ms
OUTPUTS:
2  Analog                                  0-5V, 12-bit resolution, >50K Ohm impedance
Innovate Serial Bus 2.0         RS232, 19.2Kb, up to 32-channel

!!! WARNING !!! Recently LC-1s with long sensor cables have been seen advertised , mainly through e-bay. Please be aware that this is not supported by Innovate. Extension of the sensor cable causes incorrect AFR measurements.!!!!

Scope of delivery:
LC-1 lambda controller
Bosch Wideband Sensor LSU 4.2
Serial cable to PC
daisy chain cable to connect other MTS devices
CD ROM with software
( for serial connecting to the LM-1 via log-chain you do need cable #3759 )